Standard Sealing Wax Gun | Low Temperature LetterSeal

Our Sealing Wax Gun is a standard, full sized, low temperature glue gun used with our waxes labeled as Glue Gun Waxes and Faux Sealing wax.

Production times for glue gun methods are almost ten times
faster than traditional wick wax methods.

The exact placement of your melted wax creates perfect seals time after time.

The glue gun will require at least two sticks of wax at a time, as the entering stick pushes the melting stick through.

North American Voltage
250F. (121C.)
40 Watts, 120 Volts
UL Certified

This sized glue gun will accept 7/16″ diameter sticks (not “mini” sticks). 

Video Demonstration

Considerations

☛ Please note: changing wax colors with a glue gun takes a bit of wax to complete, as a color cannot be removed once advanced into the glue gun.
The wax will melt into a pooling chamber within the gun, and new colors will mix with the old, until enough new wax can be run through to clear the color.

➢ This can create some fun combinations if you plan out your colors!

➢ If it is important for colors to not mix, you may wish to consider:
– Dedicating one glue gun to one color.
– Cutting pieces of lesser used colors to melt in our melting spoon.
– Using the glue gun wax as a wickless sealing wax and melting near a flame.

➤➤ PLEASE NOTE:
If the sealing wax is not given time to melt during use, the pressure of the advancing stick into the melting chamber could potentially force hot melting wax back up along the stick and out of the trigger area of the gun.
This is not a defect of the glue gun.
Pulling the stick back a bit to relieve the pressure, and allowing the wax time to melt will prevent further “backflow”, and the cooled wax around the collar can be removed with a little attention – this should not interfere with further use.